HOME > PRODUCTS > POWER AMPLIFIERS
CONTROL-2.6 CONTROL-1.6 VS-50 VS-40 VS-34 VS-20 VS-15
VS-2004 VS-1204 VS-1203 DC-204 DC-10 V-2 V-3.5M
V-6 V-9 V-9T
    VS-50
 
  Front View / Rear View
  Manual / Dimensions

STK 2-4-8 ohm speaker outputs VS series power amplifiers are designed for high operating efficiency and accurate sonic performance across the full audio bandwidth, even under stressful conditions.
In order to maintain strict quality assurance standards. The VS series are built -in Digital switch mode power supply with gate isolated type driver transformers and trigger circuit for output spark current to protect output switching devices.
Have a lot of parallel output devices to make high value damping factors with H class output circuit for high efficient thermal capacity.
The STK amplifiers are protected damage from shorted outputs,over heating and DC faults for speakers.
The STK VS series are ready to deliver several thousand watts for your several high power input speaker systems.

  • Have lots paralleled output device for capable 2ohm load and high damping factors.
  • Specially designed for 4 ohm bridge mode power output.
  • Powerful digital dual power supply for high power output regulation.
  • Excellent thermal capacity and lowest AC current draw.
  • Precision controlled 7 way full protection circuitry (Over heat, Over current, DC detection, Short load, Main voltage detector, Power supply shut-down, Power ON/OFF).
  • Digital control over load detector for SMPS current draw.
  • Automatic Speaker output clipping control by STK CTLL circuit module.
 
SPECIFICATIONS
>
Model VS-50
Stereo Mode (both channel driven) Continuous Average Output Per Channel
FTC @ THD+N=0.1%, f=20Hz~20kHz Ch1 Ch2
8 ohm/Stereo 1400W 1400W
4 ohm/Stereo 2050W 2050W
2 ohm/Stereo 2450W 2450W
EIA @ THD+1=1%, f=1kHz
8 ohm/Stereo 1450W 1450W
4 ohm/Stereo 2150W 2150W
2 ohm/Stereo 2500W 2500W
Bridge Mono Mode(both channel driven)
8 ohm/Stereo 4000W
4 ohm/Stereo 5000W
Power Bandwidth
(Ref. 1kHz, THD+N=0.1%,+0/-1dB)
20Hz~20kHz
THD+N
(Ref. 1kHz,f=20Hz~20kHz)
¡Â0.05%
Frequency Response
(Ref. 1kHz, 1watt output, +0/-1dB)
20Hz~30kHz
IMD(SMPTE4:1)
(60Hz:7kHz, 4:1 Half power)
 
4-8 ohm/Stereo ¡Â0.1%
2 ohm/Parallel ¡Â0.1%
8 ohm/Bridge ¡Â0.1%
Crosstalk
(RL=8¥Ø, Half power, Att.Max 600¥Ø shunt)
¡Ã64dB, 1 kHz
Residual Noise
(20Hz~22kHz LPF,Att.min)
¡Ã70dB
S/N Ratio
(Filter:A-Weighting, RMS)
¡Ã107dB
Damping Factor
(RL=8¥Ø, f=1kHz)
¡Ã400
Input Sensitivity (Att. max)
4 ohm/Stereo +0 or +4.0 or +7.0 dBu By Select Switch
8 ohm/Bridge Up to +2.1 dBu from 4 ¥Ø/Stereo Input
Voltage Gain(Att. max) 41.56dB
Output Circuitry H Class 3-Step
Input Impedance 6k¥Ø(Unbalance), 12k¥Ø(Balance)
Controls  
Front panel AC Switch,Ch1 and Ch2 gain knobs
Rear panel Low cut 30Hz Filter Output clip limiter, Sensitivity, ST/Mono Bridge, Parallel
Connectors  
Input Neutrick Female XLR jack
Output XLR Male Jack(In put Through)
Speakon Jack
Indicators Protect(Red),Power (Green), Mono Bridge (yell), Parallel(Green),Peak Clip (Red), 3 step level meter (Green)
Protection Circuits   1)Short Circuits
2)Current Limit
3)DC detection
4)Thermal
5)Main Voltage Detect
6)Power supply shutdown
7)AC Line fuse
 
Fan Circuit Four Fans Variable Low Speed(50¡É),
High speed(60¡É)
Power Consumption
(1/3 power)
3050Watts
DIMENSION 480mm X 110mm X 495mm
Shipipng Weight & volume 19.90kg / 0.0788cbm
*0dB=0.775V
*Specifications Subject to change without notice.
 
Copyright © 2007. stkpro.com All right reserved.
E-mail : stkcom@stkpro.com